0.028 Thick KYDEX V Sheet 12”x12” Shear Cut Black 8 Pack
KYDEX V Sheet - 0,028' Thick,Black,12”x12” Shear Cut,8 Pack: Industrial & Scientific,KYDEX V Sheet - 0,028" Thick,Black,12”x12” Shear Cut,8 Pack: Industrial & Scientific,Kydex® V is a recycled grade of Kydex® 100 and Kydex® T,Higher breakage resistance than competitive thermoplastics as measured by the Notched Izod test,Among the most rigid of thermoforming materials with a modulus of elasticity of 2,482 MPa,360,000 psi,Easy to form with excellent part definition and deep-draw characteristics,Great for knife sheaths and gun holsters,KYDEX® V,KYDEX® V sheet has excellent forming properties,which results in uniform wall thicknesses and crisp detail,KYDEX® V sheet forms to deep draws with low forces when heated to the upper end of the forming temperature range,Unlike many other thermoforming sheets,KYDEX® V sheet has unusually high resistance to hot tearing,Forming Guidelines,- Oven temperatures should be set differently than the settings used for ABS or FR-ABS,- Typical heater settings,percentage timers,are 30% – 50% top heaters and 50% - 70% bottom heaters,- The most frequent problem is trying to heat the sheet too quickly,particularly on the primary surface,- Cycle times will vary depending on the oven conditions and grade of KYDEX® V sheet being formed,- When forming KYDEX® V sheet,it is better to rely on the sheet appearance during heating than on fixed cycle times,- Forming temperatures – Guidelines:,Sheet should not exceed 204°C,400°F,5 - 77°C,330 - 350°F,for <,50mm,00",82 - 9°C,30 - 385°F,for,50mm to 3,20mm,00" to 0,",9 - 204°C,385 - 400°F,for > 3,20mm,",- Ideally the core sheet temperature should be within 0°F of the surface temperature,Sheet Appearance During Heating,As KYDEX® V sheet is heated,the inherent stresses in the sheet will relax,• Stage I: The heating is marked by wide undulations and softening,• Stage II: The material will start to form small ripples,known as oil canning,• Stage III: The material will start to smooth out and sag,KYDEX® V sheet will generally sag less than other thermoplastics due to its high melt strength,• Stage IV: The ripples will have smoothed out indicating that most stresses have been removed,0 to 30 seconds afterwards the sheet is ready to form
0.028 Thick KYDEX V Sheet 12”x12” Shear Cut Black 8 Pack
- Springfield Leather Company Antique Brass Indian Head Coin Upholstery Tack 25 Pack
- WEIJ 5 Pack 6204RS Bearings 20mm x 47mm x 14mm Double Rubber Sealed Deep Groove Ball Bearings
- Key Fobs and Credit Cards Anti-tracking EDEC Large Non-Window Size Faraday Bag- Signal Blocking Anti-spying Radiation protection for Cell Phones
- Learniture Rectangle Collaborative Desk with Curved Edge Pack of 2 LNT-INM1034GS Gray
- The Hillman Group 58083 Sleeve Bearing 4-Pack Bronze 5/8 X 3/4 X 1-Inch
- Bosch DSB1015B DareDevil Standard Spade Bit 1-1/8-Inch by 6-Inch
- Gabriel 77952 MAX CONTROL Monotube Shock Absorber
